The following is an overview of the user manual for the Z-Wave product Da Vinci Wall Controller (Da Vinci v4)from Contec - intelligent housing. To view other Z-Wave products and manuals from Contec follow that link.
Overview
Security
As a Z-Wave Plus certified product, Da Vinci Wall Controller supports Z-Wave S2 security. The following security modes are directly supported:
Features
Contec describes Da Vinci Wall Controller as having the following features:
- Switch Type
- Window Covering Control Features
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
Factory reset Da Vinci Wall Controller
Double Press the following buttons in the
following order 8,1,3.
Use the reset procedure only when the primary controller is missing or inoperable.
Press the #1 button 3 times.
Press the #1 button 3 times.
Please note that this is a user manual Da Vinci Wall Controller from Contec - intelligent housing is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Da Vinci Wall Controller and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.