The following is an overview of the user manual for the Z-Wave product 2-Channel Wall Switch (NAS-SC01ZE-2)from Coolcam. To view other Z-Wave products and manuals from Coolcam follow that link.
Overview
The device has 2 main functions: Switch and Timing.
There are two ways for controlling the wall switch.
The one is touch button to turn on/off switch. Another is Z-Wave command class via network.
The device also provides the function of timing, and users can turn off the device by opening this
function and setting the time cycle, the setting method of which is shown in "Command Class Configuration".
Security
As a Z-Wave Plus certified product, 2-Channel Wall Switch supports Z-Wave S2 security. The following security modes are directly supported:
- S2 Unauthenticated
Features
Coolcam describes 2-Channel Wall Switch as having the following features:
- Firmware updatable via a compatible Z-Wave gateway
- Outdoor Use
- Z-Wave Scene Type
- Communications Connections
- Communications Protocol
- Loads Controlled
- Supported Notification Types
- Thermostat Power Source
- Switch Type
- Electric Load Type
- Sensors
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
1、 Set Z-Wave™ Controller into inclusion mode
2、 Power on the device.
3、 Touch any button 3 times within 1s.
4、 The device will be entered into
inclusion mode automatically.
1、 Set Z-Wave™ Controller into exclusion mode
2、 Power on the device.
3、 Touch any button 3 times within 1s
4、 The Device will be entered into
exclusion mode automatically.
Factory reset 2-Channel Wall Switch
1、 Power on the device.
2、 Keep holding touched the button for 10s until the led turn to red, then release.
Please include a request to use the reset procedure only when the primary controller is missing or inoperable.
Please note that this is a user manual 2-Channel Wall Switch from Coolcam is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have 2-Channel Wall Switch and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.