The following is an overview of the user manual for the Z-Wave product Motion Sensor (PIR) (NAS-PD01ZE)from Coolcam. To view other Z-Wave products and manuals from Coolcam follow that link.
Overview
In the Back casing, there is a button that is used to carry out include, exclude, wake up device or reset factory default settings.
When power is first supplied, the LED will flash on and off alternately at one second intervals within 5 seconds if the detector has not been added a Z‐Wave network. Please get familiar with the terms below before starting the operations.
Security
As a Z-Wave Plus certified product, Motion Sensor (PIR) supports Z-Wave S2 security. The following security modes are directly supported:
Features
Coolcam describes Motion Sensor (PIR) as having the following features:
- Firmware updatable via a compatible Z-Wave gateway
- Z-Wave Scene Type
- Battery Quantity
- Battery powered using CR123A batteries
- Color
- Communications Connections
- Communications Protocol
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
1.Remove the sensor cover.
2.Make sure the sensor is powered.
3.Set Z‐Wave controller or Z‐Wave gateway into inclusion mode (Refer to the controller or gateway operating manual)
4.Press the button three times within 1.5 second, the device will enter inclusion mode. And the LED will flash on and off alternately five times.
1.Remove the device cover.
2.Make sure the sensor is powered.
3.Set Z‐Wave controller or Z‐Wave gateway into exclusion mode (Refer to the controller or gateway operating manual)
4.Press the button three times within 1.5 second, the device will enter exclusion mode.
1. Remove the sensor cover.
2. Make sure the sensor is powered.
3. Set Z‐Wave controller or Z‐Wave gateway into inclusion mode (Refer to the controller or
gateway operating manual)
4. Press the button three times within 1.5 second, the device will enter inclusion mode. And the
LED will flash on and off alternately five times.
Factory reset Motion Sensor (PIR)
Reset procedure will delete all information on the Z‐Wave network and Z‐Wave controller or Z‐Wave Gateway, and restore the sensor to factory default settings.
1.Remove the device cover.
2.Make sure the sensor is powered.
3.Press and hold the button for 10 seconds, Led will blink once.
4.Release the button.
Note: to use the reset procedure only when the primary controller is missing or inoperable.
You can press the button once to wake up the device and send wakeup notification to controller. If press successfully, the LED will blink one time
Please note that this is a user manual Motion Sensor (PIR) from Coolcam is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Motion Sensor (PIR) and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.