The following is an overview of the user manual for the Z-Wave product PIR sensor (NAS-PD01Z)from Coolcam. To view other Z-Wave products and manuals from Coolcam follow that link.
Overview
This product can be included and operated in any Z-Wave network with other Z-Wave certified devices from other manufacturers and/or other applications. All non-battery operated nodes within the network will act as repeaters regardless of vendor to increase reliability of the network.
In the Back casing, there is a button that is used to carry out include, exclude, wakeup device or reset factory default settings.
When power is first supplied, the LED will flash on and off alternately at one second intervals within 5 seconds if the detector has not been added a Z-Wave network. Please get familiar with the terms below before starting the operations.
Security
As a Z-Wave Plus certified product, PIR sensor supports Z-Wave S2 security. The following security modes are directly supported:
Features
Coolcam describes PIR sensor as having the following features:
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
Delete the Sensor (Motion detector) from Z-Wave Network
1.Remove the device cover.
2.Make sure the sensor is powered.
3.Set Z-Wave controller or Z-Wave gateway into exclusion mode (Refer to the controller or gateway operating manual)
Press the button three times within 1.5 second, the device will enter exclusion mode.
Wakeup Motion Detector
You can press the button once to wake up the device and send wakeup notification to controller. If press successfully, the LED will blink one time.
Add the Sensor (Motion detector) to Z-Wave Network
1.Remove the sensor cover.
2.Make sure the sensor is powered.
3.Set Z-Wave controller or Z-Wave gateway into inclusion mode (Refer to the controller or gateway operating manual)
4.Press the button three times within 1.5 second, the device will enter inclusion mode. And the LED will flash on and off alternately five times.
Factory reset PIR sensor
Restore the Sensor (Motion detector) to Factory Default Settings
Reset procedure will delete all information on the Z-Wave network and Z-Wave controller or Z-Wave Gateway, and restore the sensor to factory default settings.
1.Remove the device cover.
2.Make sure the sensor is powered.
3.Press and hold the button for 10 seconds, Led will blink once.
4.Release the button.
Please note that this is a user manual PIR sensor from Coolcam is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have PIR sensor and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.