The following is an overview of the user manual for the Z-Wave product Siren Alarm (NAS-AB01Z)from Coolcam. To view other Z-Wave products and manuals from Coolcam follow that link.
Overview
When power is first supplied, the LED will flash on and off alternately at one second intervals within 5 seconds if the detector has not been added a Z‐Wave network. Please get familiar with the terms below before starting the operations.
This product can be included and operated in any Z‐Wave network with other Z‐Wave certified devices from other manufacturers and/or other applications. All non‐battery operated nodes within the network will act as repeaters regardless of vendor to increase reliability of the network.
Security
As a Z-Wave Plus certified product, Siren Alarm supports Z-Wave S2 security. The following security modes are directly supported:
Features
Coolcam describes Siren Alarm as having the following features:
- Battery powered using CR123A batteries
- Color
- Communications Connections
- Communications Protocol
- Firmware updatable via a compatible Z-Wave gateway
- Z-Wave Scene Type
- Battery Quantity
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
1. Remove the siren cover.
2. Make sure the siren is powered.
3. Set Z‐Wave controller or Z‐Wave gateway into inclusion mode (Refer to the controller or
gateway operating manual)
4. Press the button three times within 1.5 second, the device will enter inclusion mode. And the
LED will flash on and off alternately five times.
Note: If siren has not been added to Z‐wave network, the siren will enter inclusion mode
automatically when it is powered on. You should let the controller enter into inclusion first
before power on the siren in order to run this function.
1. Remove the siren cover.
2. Make sure the siren is powered.
3. Set Z‐Wave controller or Z‐Wave gateway into exclusion mode (Refer to the controller or
gateway operating manual)
4. Press the button three times within 1.5 second, the device will enter exclusion mode.
You can press the button once to wake up the device and send wakeup notification to controller. If press successfully, the LED will blink one time
In the front casing, there is button that is used to carry out include, exclude or reset factory
default settings on PCB Board.
When power is first supplied, the LED will flash on and off alternately at one second intervals
within 5 seconds if the detector has not been added a Z‐Wave network. Please get familiar with
the terms below before starting the operations.
This product can be included and operated in any Z‐Wave network with other Z‐Wave certified
devices from other manufacturers and/or other applications. All non‐battery operated nodes
within the network will act as repeaters regardless of vendor to increase reliability of the
network.
Factory reset Siren Alarm
Reset procedure will delete all information on the Z‐Wave network and Z‐Wave controller or
Z‐Wave Gateway, and restore the siren to factory default settings.
1. Remove the device cover.
2. Make sure the siren is powered.
3. Press and hold the button for 10 seconds, led will blink once.
4. Release the button.
Note: to use the reset procedure only when the primary controller is missing or inoperable.
Please note that this is a user manual Siren Alarm from Coolcam is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Siren Alarm and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.