Smart Power Adaptor Zwischenstecker (PSMZ0002) manual for Z-Wave

The following is an overview of the user manual for the Z-Wave product Smart Power Adaptor Zwischenstecker (PSMZ0002)from COQON . To view other Z-Wave products and manuals from COQON follow that link.

  1. Overview
  2. Security
  3. Features
  4. Installation instructions


Smart Power Adaptor Zwischenstecker
SKU Code
The adaptor allows the remote controlled switching on and off of the connected electrical devices.
It also measures current power consumption and total cumulative consumption.

Increase your comfort:
Wake up in the morning from the radio, the light goes on and the coffee machine is already preheated.

Save energy costs:
Disconnect power to your devices at the touch of a button or at a time you specify. - Save energy and costs.
Version #
HW: 0 FW: 1.04 was the version certified
Certification #
Z-Wave Version


As a Z-Wave Plus certified product, Smart Power Adaptor Zwischenstecker supports Z-Wave S2 security. The following security modes are directly supported:

  • S2 Unauthenticated


COQON describes Smart Power Adaptor Zwischenstecker as having the following features:

  • Electric Load Type
  • Firmware updatable via a compatible Z-Wave gateway
  • Switch Load Capacity Current
  • Switch Load Capacity Volt-Ampere
  • Color
  • Supported Meter Type
  • Supported Notification Types
  • FLiRS capable
  • Supports Network Wide Inclusion
  • Supports Z-Wave Explorer Frames
  • Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via

Installation instructions

Factory reset Smart Power Adaptor Zwischenstecker

To set the device back to factory default press the function key for 10 seconds. The LED will flash red 5 times and then turn off.
Please use this procedure only when the primary controller is missing or inoperable.

First start the COQON App. Select the device you want to remove and tap on the trash can icon to start the ""exclusion"" process , then press ""exclude now"". After the 30 seconds countdown has started press the function key 3 times within 2 seconds to remove the Device.

First start the COQON App. Select ""Device"" then ""Settings"" and tap on ""+"" to add yo ur Smart Plug. Select ""Add new COQON Device"" then scan the data code of the device or type in the product code manually and press Enter. Now follow the steps in the app and press ""inclusion"". After the 30 seconds countdown has started press the function key 3 times within 2 seconds to add the Device. Once connected, the Smart Plug LED will stop flashing.

Please note that this is a user manual Smart Power Adaptor Zwischenstecker from COQON is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. only warrants and is only able to support products purchased directly from us. If you have Smart Power Adaptor Zwischenstecker and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.