The following is an overview of the user manual for the Z-Wave product Window Sensor Fensterkontakt Z-Wave (FKABZ002)from COQON . To view other Z-Wave products and manuals from COQON follow that link.
Overview
With this contact, you keep track of all windows and doors - even when you're on the move.
The window contact offers maximum security in your home and ensures safe protection against unauthorized access.
He controls windows, doors or gates for you and can also control devices or smart scenes.
Increase your comfort:
In connection with a light control, for example, when entering the house, the lighting in the hallway can be switched on automatically.
Feel safer:
In the event of unauthorized access, an alarm is automatically triggered. At the same time you receive on request a push message.
Protection class: IP20
Battery life: up to 5 years
Control of operation: Red LED
Scope of delivery: Transmitter module and magnetic bracket incl. Batteries and mounting set
Dimensions: Magnetic angle: 55 x 15 x 12 mm, Transmitter module: 55 x 40 x 12 mm
Version: Basic
Power voltage: 1x CR3032 lithium batteries
Operating temperature range: -15 ° C to 85 ° C (+/- 2.5 ° C)
Color: white RAL 9016
Radio protocol: Z-Wave Plus
Security
As a Z-Wave Plus certified product, Window Sensor Fensterkontakt Z-Wave supports Z-Wave S2 security. The following security modes are directly supported:
- S2 Unauthenticated
Features
COQON describes Window Sensor Fensterkontakt Z-Wave as having the following features:
- Firmware updatable via a compatible Z-Wave gateway
- Battery Quantity
- Outdoor Use
- Sensors
- Supported Notification Types
- Battery powered using CR3032 batteries
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
Factory reset Window Sensor Fensterkontakt Z-Wave
Factory reset:
1. Remove battery
2. Hold the Tamper
3. Insert Battery
4. Release Tamper within 5 sec.
Note: Please use this procedure only when the primary controller is missing or inoperable!
To remove your device from the system, please start the exclusion process to exclude the device from the COQON App. The device will be reset.
To add the product to the system, please follow the following steps.
1. Start the COQON App
2. Select ""Device"" then ""Settings"" and tap on ""+"" to add your Window Sensor
3. Select COQON
4. Follow the steps in the App
Please note that this is a user manual Window Sensor Fensterkontakt Z-Wave from COQON is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Window Sensor Fensterkontakt Z-Wave and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.