The following is an overview of the user manual for the Z-Wave product Ball Valve Servo (BVS-ZWU)from Custos. To view other Z-Wave products and manuals from Custos follow that link.
Overview
Key features:
1. Hassle free bare hand install in 20 seconds
2. Outdoor proof, can be deployed on water main outside your house
3. Build-in local leak detection probe, can work standalone
4. Elbow friendly, adjustable clamp span can fit in smallest space or oversized valve up to 1.25 inches
5. Smart adaptive torque control and self calibration, real plug and play without any hassle for adjustment or calibration.
Security
As a Z-Wave Plus certified product, Ball Valve Servo supports Z-Wave S2 security. The following security modes are directly supported:
- S2 Authenticated
- S2 Unauthenticated
Features
Custos describes Ball Valve Servo as having the following features:
- Outdoor Use
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
SmartStart location
SmartStart QR code's location as follows: The DSK is printed on the product itself and also packaging label can be found outside the giftbox
Remove Custos BVS from Z-Wave Network:
Set your Z-Wave Gateway into Exclusion mode / Remove device.
i. Start: Short press Touch Sense Button 3 times.
ii. Processing: Yellow LED and short beep sound keeping continue.
iii. Success: Green LED on 1 second with 2 short beep sounds.
iv. The LED indication Changes to Yellow LED blinking.
Factory reset Ball Valve Servo
Factory Default Reset:
To remove Custos BVS without involve gateway in Exclusion / Remove device operation and BVS will reset all setting to Factory Default
Setting.
i. Start: Long hold Touch Sense Button for 10 seconds then short click 5 times.
ii. Processing: Yellow LED ON 1 second then wait 2-5 seconds.
iii. Success: Green LED on 2 second with long beep sounds for 2 seconds.
*Factory Default Reset will:
a. Remote the BVS from Z-Wave Network;
b. Delete the association setting;
c. Restore the configuration settings to the default.
None
Classic Inclusion:
Set your Z-Wave Gateway into Inclusion mode / Add device.
i. Start: Short press Touch Sense Button 3 times.
ii. Processing: Yellow LED and short beep sound keeping continue. For security inclusion support, you may need to entering first 5 digit
that show on QR Code label, please refer to the instructions of central controller.
iii. Success: Green LED on 1 second with 2 short beep sounds.
iv. The LED indication changes to Green LED slow blinking from Yellow LED blinking.
Please note that this is a user manual Ball Valve Servo from Custos is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Ball Valve Servo and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.