The following is an overview of the user manual for the Z-Wave product D-Link mydlink Connected Home Hub (DCH-G022)from D-Link Corporation. To view other Z-Wave products and manuals from D-Link Corporation follow that link.
Overview
The key features are listed below.
1. Easy to Install
Simple to set up using the mydlink App for your tablelet and smart phone. Uses D-Link proprietary protocol for easier communication with all your mydlink home devices.
2. Wireless 802.11 Wi-Fi
3. Z-Wave Plus
Z-Wave 500 series chip
Speed up to 100kbps
4. Security
AES 128 bit encryption for Z-Wave
WPA/WPA 2 encryption for Wi-Fi
Security
As a Z-Wave Plus certified product, D-Link mydlink Connected Home Hub supports Z-Wave S2 security. The following security modes are directly supported:
Features
D-Link Corporation describes D-Link mydlink Connected Home Hub as having the following features:
- Firmware updatable via a compatible Z-Wave gateway
- Communications Protocol
- Color
- Electric Load Type
- Switch Load Capacity Current
- Switch Load Capacity Volt-Ampere
- Switch Load Capacity Watts
- Sensors
- Z-Wave Scene Type
- Communications Connections
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
This process (also known as ""Add/Adding"") is achieved by pressing “Wireless button” on DCH-G022 or pushing the [Include NEW Device] button on GUI being into the inclusion mode.
This process is achieved by holding “Wireless button” for 5 seconds on DCH-G022 or pushing the [Exclude Device] button on GUI being into the exclusion mode.
Press the [Learn Mode] button on GUI.
This is not a battery device, always in awake state.
Factory reset D-Link mydlink Connected Home Hub
Press and hold the “Reset button” for 5 seconds on DCH-G022
If this controller is the primary controller for your network, resetting it will result in the nodes in your network being orphaned and it will be necessary after the reset to exclude and re-include all of the nodes in the network. If this controller is being used as a secondary controller in the network, use this procedure to reset this controller only in the event that the network primary controller is missing or otherwise inoperable.
Please note that this is a user manual D-Link mydlink Connected Home Hub from D-Link Corporation is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have D-Link mydlink Connected Home Hub and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.