The following is an overview of the user manual for the Z-Wave product DCH-Z122 mydlink Motion Sensor (DCH-Z122)from D-Link Corporation. To view other Z-Wave products and manuals from D-Link Corporation follow that link.
Overview
Security
As a Z-Wave Plus certified product, DCH-Z122 mydlink Motion Sensor supports Z-Wave S2 security. The following security modes are directly supported:
Features
D-Link Corporation describes DCH-Z122 mydlink Motion Sensor as having the following features:
- Battery Quantity
- Battery powered using CR123A batteries
- Color
- Sensors
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
There is a button on DCH-Z122.
1. Have Z-Wave™ Controller entered inclusion mode.
2. Pressing button once to enter the inclusion mode.
3. After add successful, the device will wake to receive the setting command from Z-Wave™ Controller about 20 seconds.
There is a button on DCH-Z122.
1. Have Z-Wave™ Controller entered exclusion mode.
2. Pressing button once to enter the exclusion mode.
There is a button on DCH-Z122.
Press the button once, the device will awake 10 seconds.
Factory reset DCH-Z122 mydlink Motion Sensor
There is a button on DCH-Z122.
1. Pressing button for about 5 seconds.
2. IDs are excluded and all settings will reset to factory default.
Notice: Use this procedure only in the event that the primary controller is lost or otherwise inoperable.
Please note that this is a user manual DCH-Z122 mydlink Motion Sensor from D-Link Corporation is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have DCH-Z122 mydlink Motion Sensor and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.