Categories

Aeotec

Atrim

SmartThings

Z-Wave Products

mydlink Connected Home Hub (DCH-G020) manual for Z-Wave

The following is an overview of the user manual for the Z-Wave product mydlink Connected Home Hub (DCH-G020)from D-Link Corporation. To view other Z-Wave products and manuals from D-Link Corporation follow that link.

  1. Overview
  2. Security
  3. Features
  4. Installation instructions

Overview

Name
mydlink® Connected Home Hub
SKU Code
DCH-G020
Description
The mydlink® Connected Home Hub (DCH-G020) allows you to easily manage your mydlink Home Automation and Security products while the mydlink Home app gives you the control to manage and know your home is safe even when you are not there. The mydlink Hub is designed with Wi-Fi and Z-Wave to connect the full suite of wireless mydlink connected home devices, including battery-powered Z-Wave Open/Close and motion sensors. With the mydlink Hub and mobile app, you can turn your devices on and off, set lighting schedules, and automate the devices you use the most. When your home reacts to you, it’s not magic – but it’s pretty close.
Version #
01 was the version certified
Certification #
ZC10-15020012
Certified
2015-04-15T10:48:13.1256
Z-Wave Version
6.51.03

Security

As a Z-Wave Plus certified product, mydlink Connected Home Hub supports Z-Wave S2 security. The following security modes are directly supported:

    Features

    D-Link Corporation describes mydlink Connected Home Hub as having the following features:

    • FLiRS capable
    • Supports Network Wide Inclusion
    • Supports Z-Wave Explorer Frames
    • Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via

    Installation instructions

    This process is achieved by holding “Wireless button” for 5 seconds on DCH‐G020 or pushing the [Exclude Device]
    button on GUI being into the exclusion mode.

    This process (also known as ""pairing"" and ""adding"") is achieved by pressing “Wireless button” on DCH‐G020 or
    pushing the [Include NEW Device] button on GUI being into the inclusion mode.

    Press the [Learn Mode] button on GUI.

    Factory reset mydlink Connected Home Hub

    Press and hold the “Reset button” for 5 seconds on DCH‐G020

    This is not a battery device, always in awake state.

    N/A

    Please note that this is a user manual mydlink Connected Home Hub from D-Link Corporation is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have mydlink Connected Home Hub and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.