The following is an overview of the user manual for the Z-Wave product mydlink Motion Sensor (DCH-Z122)from D-Link Corporation. To view other Z-Wave products and manuals from D-Link Corporation follow that link.
Overview
Security
As a Z-Wave Plus certified product, mydlink Motion Sensor supports Z-Wave S2 security. The following security modes are directly supported:
Features
D-Link Corporation describes mydlink Motion Sensor as having the following features:
- Battery Quantity
- Battery powered using CR123A batteries
- Color
- Sensors
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
There is a button on DCH-Z122.
Press the button once, the device will awake 10 seconds.
Factory reset mydlink Motion Sensor
There is a button on DCH-Z122.
1. Pressing button for about 5 seconds.
2. IDs are excluded and all settings will reset to factory default.
Notice: Use this procedure only in the event that the primary controller is lost or otherwise inoperable.
There is a button on DCH-Z122.
1. Have Z-Wave™ Controller entered exclusion mode.
2. Pressing button once to enter the exclusion mode.
There is a button on DCH-Z122.
1. Have Z-Wave™ Controller entered inclusion mode.
2. Pressing button once to enter the inclusion mode.
3. After add successful, the device will wake to receive the setting command from Z-Wave™ Controller about 20 seconds.
Please note that this is a user manual mydlink Motion Sensor from D-Link Corporation is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have mydlink Motion Sensor and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.