The following is an overview of the user manual for the Z-Wave product Danalock (DanalockBTZE100Circle)from Danalock. To view other Z-Wave products and manuals from Danalock follow that link.
Overview
Operated by Z-Wave.
Connect Danalock to your Z-Wave gateway - Danalock interfaces with your existing Z-Wave network through the Danalock smartphone app.
Operate Danalock remotely by accessing your Z-Wave network from anywhere in the world with internet access.
Security
As a Z-Wave Plus certified product, Danalock supports Z-Wave S2 security. The following security modes are directly supported:
Features
Danalock describes Danalock as having the following features:
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
To add or include the danalock into a Z-Wave network
Set the controller in inclusion mode
Touch the User Button until you hear two beeps.
To remove or exclude the danalock into a Z-Wave network
Set the controller in exclusion mode
Touch the User Button until you hear two beeps.
Factory reset Danalock
The danalock can be set to factory settings by holding the User Button for ten beeps. Please use this procedure only when the primary controller is missing or otherwise inoperable.
Please note that this is a user manual Danalock from Danalock is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Danalock and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.