The following is an overview of the user manual for the Z-Wave product Universal Module Version 3 (UMV3-BTZE-EU)from Danalock. To view other Z-Wave products and manuals from Danalock follow that link.
Overview
- S0/S2 Z-Wave Security
- Can operate 3 outputs.
- Outputs can be delayed.
- Bluetooth Smart
Security
As a Z-Wave Plus certified product, Universal Module Version 3 supports Z-Wave S2 security. The following security modes are directly supported:
- S2 Access Control
Features
Danalock describes Universal Module Version 3 as having the following features:
- Supported Notification Types
- Firmware updatable via a compatible Z-Wave gateway
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
Factory reset Universal Module Version 3
The UMV3 can be set to factory settings by pushing the switch 10 times. Please use this procedure only when
the primary controller is missing or otherwise inoperable.
To add or include the UMV3 into a Z-Wave network
1. Set the controller in inclusion mode
2. Push the switch once.
3. Wait 5 seconds.
To remove or exclude the UMV3 into a Z-Wave network
1. Set the controller in exclusion mode
2. Push the switch once.
3. Wait 5 seconds.
Please note that this is a user manual Universal Module Version 3 from Danalock is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Universal Module Version 3 and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.