The following is an overview of the user manual for the Z-Wave product V3-btzh-anz (V3-BTZH-ANZ)from Danalock. To view other Z-Wave products and manuals from Danalock follow that link.
Overview
- S0/S2 Z-Wave Security
- Bluetooth Smart
- Twist Assist
- Auto Lock
- Hold And Release
- Back To Back
Security
As a Z-Wave Plus certified product, V3-btzh-anz supports Z-Wave S2 security. The following security modes are directly supported:
- S2 Access Control
Features
Danalock describes V3-btzh-anz as having the following features:
- Battery Quantity
- Battery powered using CR123 batteries
- Supported Notification Types
- Firmware updatable via a compatible Z-Wave gateway
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
Factory reset V3-btzh-anz
The Danalock can be set to factory settings by pushing the switch ten times. Please use this procedure only when the primary controller is missing or otherwise inoperable.
1. Set the controller in inclusion mode
2. Push the switch once.
3. Wait 5 seconds.
1. Set the controller in exclusion mode
2. Push the switch once.
3. Wait 5 seconds.
Please note that this is a user manual V3-btzh-anz from Danalock is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have V3-btzh-anz and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.