The following is an overview of the user manual for the Z-Wave product V3-btzh-kr (Danalock V3-BTZH-KR)from Danalock. To view other Z-Wave products and manuals from Danalock follow that link.
Overview
- S0/S2 Z-Wave Security
- Bluetooth Smart
- Twist Assist
- Auto-Lock
- Hold And Release
- End to End
Security
As a Z-Wave Plus certified product, V3-btzh-kr supports Z-Wave S2 security. The following security modes are directly supported:
- S2 Access Control
Features
Danalock describes V3-btzh-kr as having the following features:
- Firmware updatable via a compatible Z-Wave gateway
- Supported Notification Types
- Battery Quantity
- Battery powered using CR123A batteries
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
SmartStart location
SmartStart QR code's location as follows: The DSK can be found inside the battery lid of the product.
1. Set the controller in inclusion mode
2. Push the switch once.
3. Wait 5 seconds.
1. Set the controller in exclusion mode
2. Push the switch once.
3. Wait 5 seconds.
Mailbox command class is not supported.
Factory reset V3-btzh-kr
The Danalock can be set to factory settings by pushing the switch ten times. Please use this procedure only when the primary controller is missing or otherwise inoperable.
Please note that this is a user manual V3-btzh-kr from Danalock is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have V3-btzh-kr and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.