The following is an overview of the user manual for the Z-Wave product Power Manager (PM-B400ZW)from Dawon DNS. To view other Z-Wave products and manuals from Dawon DNS follow that link.
Overview
Security
As a Z-Wave Plus certified product, Power Manager supports Z-Wave S2 security. The following security modes are directly supported:
Features
Dawon DNS describes Power Manager as having the following features:
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
After mounting the UZB controller to your PC and running the PC Controller program, click the Add button in the PC Controller program. Press the button on the Smart Plug for more than five seconds after you plug the Smart Plug into a power outlet and it will include to the network controller, while flashing the red button on the LED Smart Plug.
After mounting the UZB controller to your PC and run the PC Controller program you can click the Remove button in the PC Controller program. Press the button on the Smart Plug for more than five seconds after you plug the Smart Plug into a power outlet will Exclusion in the network controller, while the flashing red button LED Smart Plug.
Factory reset Power Manager
Press the button on the Smart Plug for more than 10 seconds after you plug the Smart Plug into a power outlet will make a Exclusion in the network controller, while the flashing red button LED Smart Plug. And all the variables are initialized.
※ Please use this procedure only in the event that the network primary
controller is missing or otherwise inoperable
Please note that this is a user manual Power Manager from Dawon DNS is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Power Manager and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.