The following is an overview of the user manual for the Z-Wave product P-m-o (RPB11647BSB)from DeepSense. To view other Z-Wave products and manuals from DeepSense follow that link.
You can completely replace your regular outlet.
You can connect home appliances such as home lamps, TVs, and others.
The power status can be remotely controlled, and the LED indication changes according to the power status.
As a Z-Wave Plus certified product, P-m-o supports Z-Wave S2 security. The following security modes are directly supported:
DeepSense describes P-m-o as having the following features:
- Supported Meter Type
- Switch Load Capacity Volt-Ampere
- Switch Load Capacity Watts
- Switch Load Capacity Current
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
When the controller is in remove mode, press and hold the button for 3 seconds until the RED LED indicator flashes. When the P-M-O unit is disconnected from the Z-Wave network, the RED LED indicator will be toggled every second.
When the controller is in add mode, press and hold the button for 3 seconds until the RED LED indicator blinks.
Factory reset P-m-o
Press and hold button for 10 seconds until green and red led indicators blink.
P-M-O will be initialized and send a device reset locally notification to the controller. Use this function only if the primary controller is lost or otherwise inoperable.
Please note that this is a user manual P-m-o from DeepSense is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have P-m-o and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.