Smartlock (ZW300) manual for Z-Wave

The following is an overview of the user manual for the Z-Wave product Smartlock (ZW300)from Delaney Hardware. To view other Z-Wave products and manuals from Delaney Hardware follow that link.

  1. Overview
  2. Security
  3. Features
  4. Installation instructions

Overview

Name
Smartlock
SKU Code
ZW300
Description
Delaney Hardware’s ZW300 Touchscreen Smartlock offers convenience and security for residential entry doors. Entry is made via touchscreen code, mobile app, or mechanical key. With Delaney’s smart home control app, a homeowner can manage who is entering their home from anywhere.
• ANSI Grade 3 lock with motor-driven deadbolt
• Keypad accommodates thirty user codes of four to eight digits, and a single-use code, with code-probing prevention and disablement after five attempts (warned with beeps and LED and then 45-seconds downtime)
• Delaney app utilizes Z-Wave Plus via 128-bit AES encryption, mesh networking technology, and history log. It integrates with other Z-Wave devices such as doorbells with cameras, door and window sensors, outlet controls, heat and smoke sensors, thermostats, and water leak sensors via a security-enabled Z-Wave hub, which conveniently connects through your home WiFi, or plugs into your modem.
• Configurable auto-locking (from 10-99 seconds)
• Vacation mode with time-configurable deactivation during which all user codes are disabled such that only the mechanical key.
• ANSI A156.25 compliance (water, dust, corrosion resistance)
• Easy installation in standard doors with just a screwdriver (no hard wiring)
Version #
HW: 1 FW: 1.02:01.00 was the version certified
Certification #
ZC10-18096229
Certified
2018-09-06T23:21:12.355663
Z-Wave Version
6.71.01

Security

As a Z-Wave Plus certified product, Smartlock supports Z-Wave S2 security. The following security modes are directly supported:

  • S2 Access Control

Features

Delaney Hardware describes Smartlock as having the following features:

  • Battery Quantity
  • Battery powered using AA batteries
  • Color
  • Door Lock Type
  • Outdoor Use
  • FLiRS capable
  • Supports Network Wide Inclusion
  • Supports Z-Wave Explorer Frames
  • Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via

Installation instructions

Tap ""add device"" on your app, then tap enter to lock.
Enter programming code -> confirm -> Enter 9 -> confirm
If you hear 2 long beeps from your lock the programming was successful.
If you hear short 3 beeps from your lock you must start over again.

Tap ""remove device"" on your app, then tap enter to lock.
Enter programming code -> confirm -> Enter 9 -> confirm
If you hear 2 long beeps from your lock the programming was successful.
If you hear short 3 beeps from your lock you must start over again.

Factory reset Smartlock

Press the R button for more than 5 seconds; the programming is reset back to the original factory codes once you hear 3 long beeps. Please use this procedure only when the network primary controller is missing or otherwise inoperable.

Touch the touchscreen

Please note that this is a user manual Smartlock from Delaney Hardware is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Smartlock and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.