The following is an overview of the user manual for the Z-Wave product HC Switch FM (MT 02759)from devolo. To view other Z-Wave products and manuals from devolo follow that link.
Overview
The connection of a digital temperature sensor means you can create complex scenes and control any device relative to a set temperature range. The Devolo HC Switch FM also acts as a Z-Wave repeater to improve the range and stability of the Z-Wave network.
Security
As a Z-Wave Plus certified product, HC Switch FM supports Z-Wave S2 security. The following security modes are directly supported:
Features
devolo describes HC Switch FM as having the following features:
- Sensors
- Neutral Wire Required
- Color
- Switch Load Capacity Watts
- Electric Load Type
- Supported Meter Type
- Switch Load Capacity Current
- Supported Notification Types
- Switch Type
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
REMOVAL FROM A Z-WAVE NETWORK
• Connect module to power supply
• bring module within maximum 1 meter (3 feet) of the main controller,
• enable add/remove mode on main controller
If push button I1 is pressed three times within 5s (or service button S is pressed more than 2 and less than 6 seconds) module is excluded, but configuration parameters are not set to default values.
Factory reset HC Switch FM
FACTORY RESET
• Connect module to power supply
• bring module within maximum 1 meter (3 feet) of the main controller,
• enable add/remove mode on main controller
• press push button I1 five times within 5s (5 times change switch state within 5 seconds) in the first 60 seconds after the module is connected to the power supply or
• press service button S (only applicable for 24 V SELV supply voltage) for more than 6 second.
By this function all parameters of the module are set to default values and own ID is deleted.
*Please use this procedure only when the network primary controller is missing or otherwise inoperable.
AUTOMATICALLY ADDING THE DEVICE TO A Z-WAVE NETWORK
1. Enable add/remove mode on your Z-Wave gateway (hub)
2. Connect the device to the power supply (with the temperature sensor already connected – sold separately*).
3. Auto-inclusion will be initiated within 5 seconds of connection to the power supply and the device will automatically enroll in your network
MANUALLY ADDING THE DEVICE TO A Z-WAVE NETWORK
1. Enable add/remove mode on your Z-Wave gateway (hub)
2. Connect the device to the power supply (with the temperature sensor already connected*)
3. Toggle the switch connected to the I1 terminal 3 times within 3 seconds
OR
If the device is powered by 24 V SELV supply, press and hold the S (Service) button for at least 2 seconds
4. A new multi-channel device will appear on your dashboard
*If connecting the temperature sensor, switch off the power supply and make sure the device is excluded from your network BEFORE connecting the sensor.
Make sure the device is excluded from your network before connecting the temperature sensor. Switch off the power supply, connect the temperature sensor, and re-include the device to your network.
Please note that this is a user manual HC Switch FM from devolo is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have HC Switch FM and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.