Categories

Aeotec

Atrim

SmartThings

Z-Wave Products

Smoke Detector (MT-2651) manual for Z-Wave

The following is an overview of the user manual for the Z-Wave product Smoke Detector (MT:2651)from devolo. To view other Z-Wave products and manuals from devolo follow that link.

  1. Overview
  2. Security
  3. Features
  4. Installation instructions

Overview

Name
Smoke Detector
SKU Code
MT:2651
Description
The MT-2651 is a Z-Wave enabled smoke detector which is designed to sense smoke that comes into the detector's chamber and send Z-Wave signal and warning sound (with audibility as 85dB at 3m) if it detects a certain density of smoke. The detector is battery operated and includes the ability to detects the battery level and will report an alert signal if the battery is under certain low level. The sensitivity of its sensor is meet both UL217 and EN14604 standard. The MT:2651 also supports its firmware could updated over Z-WAVE network.
Version #
was the version certified
Certification #
ZC10-14080006
Certified
2017-03-08T20:06:17.141016
Z-Wave Version
6.51.02

Security

As a Z-Wave Plus certified product, Smoke Detector supports Z-Wave S2 security. The following security modes are directly supported:

    Features

    devolo describes Smoke Detector as having the following features:

    • Battery Quantity
    • Battery powered using CR123A batteries
    • Color
    • Firmware updatable via a compatible Z-Wave gateway
    • FLiRS capable
    • Supports Network Wide Inclusion
    • Supports Z-Wave Explorer Frames
    • Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via

    Installation instructions

    Put the Z-Wave™ Interface Controller into “exclusion” mode, and following its instruction to delete the MT:2651 from your controller. Press the program switch of MT:2651 for 1 second at least to be excluded. The red LED setting light will flash continuously in Exclusion condition. (Please refer to the user manual to understand the program switch location)

    Put the Z-Wave™ Interface Controller into “inclusion” mode, and following its instruction to add the MT:2651 to your controller. To get in the “inclusion” mode, the distance between detector and controller is suggested to be in one meter. Press the program switch of MT:2651 for 1 second at least to be included. After setting, the LED Setting Lighting should go off, if not, please try again. (Please refer to the user manual to understand the program switch location)

    Press program switch once, the detector will send NIF signal first and will also send “Wake Up Notification” after 3 seconds. (Please refer to the user manual to understand the program switch location)

    Please note that this is a user manual Smoke Detector from devolo is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Smoke Detector and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.