The following is an overview of the user manual for the Z-Wave product Door/Window Sensor (DMWD1)from Dome. To view other Z-Wave products and manuals from Dome follow that link.
Overview
• Monitors if doors/windows are open or closed, can send you reminders if you left your garage door open
• Works with exterior or interior doors, garage doors, patio doors, windows, cabinets, safes, closet door, baby gates and other openings
• Z-Wave Plus Certified. Requires a Dome Home Automation Hub or other Z-Wave Certified Hub to operate
• Up to 150-foot range and 3-year battery life (CR14250 Battery Included)
• Tested to work with SmartThings, Vera, Staples Connect, HomeSeer, Nexia, Piper, URC, Harmony. Not supported by Wink, DSC, ADT Pulse, 2Gig, Napco, Interlogix, Honeywell (Dome is not associated with listed brands)
Security
As a Z-Wave Plus certified product, Door/Window Sensor supports Z-Wave S2 security. The following security modes are directly supported:
Features
Dome describes Door/Window Sensor as having the following features:
- Battery Quantity
- Battery powered using CR14250 batteries
- Color
- Sensors
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
If using the Dome Hub, open the App, navigate to the side menu tap “Device Settings,” select the device you wish to remove, and press “Delete Device.”
If using a 3rd party controller, follow the controller manufacturer’s instructions to enter exclusion mode.
When prompted by the controller:
1. Remove the SENSOR COVER from the rest of the sensor.
2. Press the Connect button quickly 3 times in a row.
A red LED will flash five times indicating exclusion/disconnection.
If using the Dome Hub, open the App, navigate to the side menu and tap “Add New Device” The App will guide you through the inclusion process.
If using a 3rd party controller, follow the controller manufacturer’s instructions to enter inclusion mode.
When prompted by the controller:
1. Remove the SENSOR COVER.
2. Remove the BATTERY TAB.
3. Press the BUTTON quickly 3 times in a row.
A red LED will flash five times indicating inclusion.
Because the Door/Window Sensor is a battery powered device, it wakes up on regular intervals to give battery and other status updates to the controller, as well as to accept configuration settings from the controller (as opposed to always remaining online and draining its battery.) The device can be forced to wake up (to submit these reports or accept new settings immediately) by simply pressing and holding the BUTTON for two seconds.
1. Remove the SENSOR COVER.
2. Remove the BATTERY TAB.
3. Press the BUTTON quickly 3 times in a row.
A red LED will flash five times indicating inclusion.
Factory reset Door/Window Sensor
If needed, the Door/Window Sensor can be reset locally by following these steps. Only do this when your Z-Wave controller is disconnected or otherwise unreachable. Beware that resetting your device will disconnect it from the system:
1. Remove the SENSOR COVER and confirm that your Door/Window Sensor is powered up.
2. Press and hold the BUTTON for at least 10 seconds then release. A flashing light indicates a successful factory reset.
3. The Door/Window Sensor’s memory will be erased to factory settings.
Please note that this is a user manual Door/Window Sensor from Dome is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Door/Window Sensor and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.