The following is an overview of the user manual for the Z-Wave product Z-Wave Plus Motion Detector (DMMS1)from Dome. To view other Z-Wave products and manuals from Dome follow that link.
Overview
● Detects movement inside your home with extra wide 110 deg. coverage and responds to activity by sending an alert to your smarthome system. Adjustable sensitivity for optimum performance based on environment
● Capable of sensing current light conditions in the room helping create smart lighting scenes. Adjustable timeout for selecting delay when lights will turn off after motion is no longer detected
● Convenient magnetic mount offering ultimate installation flexibility
● Z-Wave Plus Certified. Requires a Z-Wave Certified Hub to operate. Up to 150-foot range and 3-year battery life (CR123A Battery Included)
● Works with SmartThings, Vera, Staples Connect, HomeSeer, Nexia, Piper, URC, Harmony. Not supported: Wink, DSC, ADT Pulse, 2gig, Napco, Interlogix, Honeywell (Dome is not associated with listed brands)
Security
As a Z-Wave Plus certified product, Z-Wave Plus Motion Detector supports Z-Wave S2 security. The following security modes are directly supported:
Features
Dome describes Z-Wave Plus Motion Detector as having the following features:
- Color
- Sensors
- Battery Quantity
- Battery powered using CR123A batteries
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
Follow the instructions for your Z-Wave Certified Conto enter inclusion mode. When prompted by the controller:
1. The Motion Sensor should be within 10’ of your Z-Wave controller for the inclusion process. After successful pairing, the device can be brought to the desired location.
2. Remove the SENSOR COVER by twisting it counterclockwise.
3. Remove the BATTERY TAB.
4. Press the BUTTON quickly 3 times in a row.
5. The LED INDICATOR will flash five times indicating inclusion
Factory reset Z-Wave Plus Motion Detector
If needed, the Motion Detector can be reset locally by following these steps. Only do this when your Z-Wave controller is disconnected or otherwise unreachable. Beware that resetting your device will disconnect it from the system:
1. Remove the SENSOR COVER and confirm that your Motion Detector is powered up.
2. Press and hold the BUTTON for at least 10 seconds then release. A flashing LED INDICATOR indicates a successful factory reset.
3. The Motion Detector’s memory will be erased to factory settings.
Because the Motion Detector is a battery powered device, it wakes up on regular intervals to give battery and other status updates to the controller, as well as to accept configuration settings from the controller. This helps to extend the battery life. The device can be forced to wake up to submit these reports or accept new settings immediately by simply pressing and holding the BUTTON for two seconds. The LED INDICATOR will flash once indicating successful wake up.
Follow the instructions for your Z-Wave Certified Conto enter exclusion mode. When prompted by the controller:
1. Remove the SENSOR COVER.
2. Press the BUTTON quickly 3 times in a row.
The LED INDICATOR will flash five times indicating exclusion/disconnection.
Please note that this is a user manual Z-Wave Plus Motion Detector from Dome is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Z-Wave Plus Motion Detector and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.