Z-Wave Touchable Smart Valve (WP-02SF) manual for Z-Wave

The following is an overview of the user manual for the Z-Wave product Z-Wave Touchable Smart Valve (WP-02SF)from Dongguan Will Power. To view other Z-Wave products and manuals from Dongguan Will Power follow that link.

  1. Overview
  2. Security
  3. Features
  4. Installation instructions

Overview

Name
Z-Wave Touchable Smart Valve
SKU Code
WP-02SF
Description
WP-02SF water valve controller focuses on the handle ball valve with remote control and hand operation. The moving distance of the handle ball valve can be 90 degrees. Without changing the installed control valves of water, steam , and oil lines, just simply install this product on the original handle ball valve.
Version #
HW: 1 FW: 10.14 was the version certified
Certification #
ZC12-20110132
Certified
2020-11-24T18:20:51.714427
Z-Wave Version
7.14.1

Security

As a Z-Wave Plus certified product, Z-Wave Touchable Smart Valve supports Z-Wave S2 security. The following security modes are directly supported:

  • S2 Authenticated
  • S2 Unauthenticated

Features

Dongguan Will Power describes Z-Wave Touchable Smart Valve as having the following features:

  • Outdoor Use
  • Controller Supports Multiple Z-Wave Interfaces
  • Z-Wave Scene Type
  • Controller Supports Multiple Networks
  • Color
  • Neutral Wire Required
  • Firmware updatable via a compatible Z-Wave gateway
  • IP (Ingress Protection) Rated
  • Communications Protocol
  • Communications Connections
  • Gateway Has Preferred Partners
  • FLiRS capable
  • Supports Network Wide Inclusion
  • Supports Z-Wave Explorer Frames
  • Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via

Installation instructions

SmartStart location

SmartStart QR code's location as follows: No

Add:It will trigger ADD/REMOVE after press the OPEN button for more than 5seconds. Try again if failed. Notice: The triggering will be activated after the PRESS stopped.

B. Remove:It will trigger ADD/REMOVE after press the OPEN button for more than 5 seconds. Try again if failed. Notice: The triggering will be activated after the PRESS stopped.

Factory reset Z-Wave Touchable Smart Valve

Support Device Locally Reset
Please use this procedure only when the network primary controller is missing or otherwise inoperable.

Please note that this is a user manual Z-Wave Touchable Smart Valve from Dongguan Will Power is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Z-Wave Touchable Smart Valve and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.