The following is an overview of the user manual for the Z-Wave product Tubular motor (DM35E/F-6/28;DM35E/F-10/17;DM35E/F-13/14)from Dooya. To view other Z-Wave products and manuals from Dooya follow that link.
Overview
Percentage control
Position feedback
Electronic Limit
Switch Direction
Stall Protection
Built-in Receiver
Preferred Stop Position
Low-noise
Jog & Lift Mode
Security
As a Z-Wave Plus certified product, Tubular motor supports Z-Wave S2 security. The following security modes are directly supported:
- S2 Unauthenticated
Features
Dooya describes Tubular motor as having the following features:
- Window Covering Control Features
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
Press the motor setting button three times within 1.5 seconds. (Press P1(1 beep), Press P1(1 beep), Press P1(1 beep and 1 jog))
Press the motor setting button three times within 1.5 seconds. (Press P1(1 beep), Press P1(1 beep), Press P1(1 beep and 1 jog))
Press the motor setting button three times within 1.5 seconds. (Press P1(1 beep), Press P1(1 beep), Press P1(1 beep and 1 jog))
Factory reset Tubular motor
Press and hold P1 for 10S (Press and hold P1 button for 2S, the motor will long beep once and jog once; for 5S, 3 beeps and jog once if no limits; for 10S, 3 beeps and jog once; release the P1 button, 16 beeps and jog once.)
Please use this procedure only when the network primary controller is missing or otherwise inoperable.
Press the motor setting button three times within 1.5 seconds. (Press P1(1 beep), Press P1(1 beep), Press P1(1 beep and 1 jog))
Please note that this is a user manual Tubular motor from Dooya is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Tubular motor and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.