The following is an overview of the user manual for the Z-Wave product Plug in Dimmer Switch (PD-100)from Dragon Tech Industrial, Ltd.. To view other Z-Wave products and manuals from Dragon Tech Industrial follow that link.
Overview
• Works with any AC operated lamps with incandescent and dimmable florescent(CFL) or LED light bulbs
• ON/OFF status and location LED indicator
• Can be controlled wirelessly or manually
• Plug and play, simple setup
• Lightweight and compact.
• Grounded 3-pin AC power plug to enhance safety
• Over-The-Air firmware upgrade available with compatible gateway, Z-Wave static controller, PC and software
• Z-Wave 500 Series module inside
• Internal resettable fuse to protect from surge current
• Manual reset capability
• Adjustable dimming rate
Security
As a Z-Wave Plus certified product, Plug in Dimmer Switch supports Z-Wave S2 security. The following security modes are directly supported:
Features
Dragon Tech Industrial describes Plug in Dimmer Switch as having the following features:
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
1. Plug the 2-pin AC power plugs of lighting device to the receptacle of PD-100
2. Insert the module's 3-pin plug into an AC outlet of your preferred location. In normal operating mode, the LED on the front panel will be lit.
3. Add(Include) the module into your network by a Z-Wave certified controller.
Normally, the sequence is as follows:
a. Place your network controller into inclusion mode by following the controller manufacturer's instructions
b. When the controller is ready, single click the button on the front of PD-100
c. The controller should indicate that the new device was added successfully.
a. Place your network controller into exclusion mode by following the controller manufacturer's instructions
b. When the controller is ready, single click the button on the front of PD-100
c. The controller should indicate that the device was excluded successfully.
Factory reset Plug in Dimmer Switch
Use this procedure only in the event that the network primary controller is lost or otherwise inoperable.
1. Unplug the PD-100 from the AC outlet and also unplug the power plugs of the lighting from the module (if plugged in)
2. Press and hold the button on the PD-100
3. Plug the PD-100 back into the AC outlet with the button pressed
4. After 3 seconds, release the button. If you see the button blink, that means that the PD-100 has been reset successfully
Please note that this is a user manual Plug in Dimmer Switch from Dragon Tech Industrial, Ltd. is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Plug in Dimmer Switch and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.