The following is an overview of the user manual for the Z-Wave product Z-Wave Plug-In On/Off Appliance Module (PA-100)from Dragon Tech Industrial, Ltd.. To view other Z-Wave products and manuals from Dragon Tech Industrial follow that link.
Overview
The PA-100 uses the latest 500 series Z-Wave chip for longer range, over-air-firmware update, and easier inclusion process, providing these features are also supported by the gateway or controller.
Security
As a Z-Wave Plus certified product, Z-Wave Plug-In On/Off Appliance Module supports Z-Wave S2 security. The following security modes are directly supported:
Features
Dragon Tech Industrial describes Z-Wave Plug-In On/Off Appliance Module as having the following features:
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
1. Put your network controller into inclusion mode following the instructions from your controller manufacturer
2. When the controller is ready, single click the button on the front of PA-100
3. The controller should indicate that the new device was added successfully
1. Put your network controller into exclusion mode following the instructions from your controller manufacturer
2. When the controller is ready, single click the button on the front of PA-100
3. The controller should indicate that the device was excluded successfully
Factory reset Z-Wave Plug-In On/Off Appliance Module
Use this procedure only in the event that the network primary controller is lost or otherwise inoperable.
a. Unplug PA-100 from the AC outlet and also unplug the power plug of the appliance from the module(if plugged in)
b. Press and hold the button on the PA-100 module
c. Plug the PA-100 back into the AC outlet with the button pressed
d. After 3 seconds, release the button. If you see the button blinks, that means the module has been reset successfully
Please note that this is a user manual Z-Wave Plug-In On/Off Appliance Module from Dragon Tech Industrial, Ltd. is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Z-Wave Plug-In On/Off Appliance Module and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.