Categories

Aeotec

Atrim

SmartThings

Z-Wave Products

Door/Window Sensor (EH-DS-01) manual for Z-Wave

The following is an overview of the user manual for the Z-Wave product Door/Window Sensor (EH-DS-01)from Easy Home. To view other Z-Wave products and manuals from Easy Home follow that link.

  1. Overview
  2. Security
  3. Features
  4. Installation instructions

Overview

Name
Door/Window Sensor
SKU Code
EH-DS-01
Description
Z-Wave Door/Window sensors are designed to secure the perimeter of the residential premise, and provide the ability to add various automation services. The Z-Wave Door/Window sensor, which consists of a magnet that attaches to a door or window, will communicate door events to the home security system. When the magnet is moved away from the sensor, a signal will be sent to the control panel that communicates the changed state to the security system. Signals can also be used to activate a chime or convenience lighting based on system settings.
Version #
HW: 255 FW: 1.25 was the version certified
Certification #
ZC10-16125349
Certified
2016-12-15T16:39:58.839936
Z-Wave Version
6.51.07

Security

As a Z-Wave Plus certified product, Door/Window Sensor supports Z-Wave S2 security. The following security modes are directly supported:

    Features

    Easy Home describes Door/Window Sensor as having the following features:

    • Battery Quantity
    • Battery powered using CR123A batteries
    • Color
    • Sensors
    • FLiRS capable
    • Supports Network Wide Inclusion
    • Supports Z-Wave Explorer Frames
    • Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via

    Installation instructions

    For Removing from (Exclusion) a network: Put the Z-Wave Interface Controller into “Remove (Exclusion)” mode, and following its instruction to delete EH-DS-01 to your Z-Wave controller.
    1. Remove device front cover and pressing the button three times within 2 seconds, The Red LED indicator will be flashing three times and enter exclusion mode.
    2. If remove (exclusion) successful, go auto Adding procedure.
    3. Node ID has been remove.

    For Adding in (Inclusion) a network: Put the Z-Wave Interface Controller into “Add (Inclusion)” mode, and following its instruction to add EH-DS-01 to your controller. This Door/Window sensor needs to be included before installation.
    1. Pull the exposed plastic tab from the sensor.
    2. Press the button three times within 2 seconds, The Red LED indicator will be flashing three times to indicate scanning the network.
    3. If network is not found after 30 seconds, the sensor will go into sleep mode. To Adding again, you need repeat steps 2

    Factory reset Door/Window Sensor

    1. Pressing the button before power on, do not release the button and power on and keep on ten seconds, and the LED will turn ON.
    2. After over 1 seconds the Red LED indicator will turn OFF, then go auto Adding procedure.
    3. IDs are excluded and all settings will reset to factory default.
    4. Device begin auto Adding (Inclusion) mode.
    Note: Use this procedure only in the event that the primary controller is lost.

    Please note that this is a user manual Door/Window Sensor from Easy Home is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Door/Window Sensor and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.