The following is an overview of the user manual for the Z-Wave product Plug-In Module - ON/OFF (RF96APM)from Eaton. To view other Z-Wave products and manuals from Eaton follow that link.
Overview
• Provides wireless control of one outlet leaving the other outlet always ON
• Rated for up to 12A plug loads and up to 300W of LEDs
• Can be associated with up to 4 other devices
• Supports Z-Wave Plus functionality with S2 security certification
• Voice and app based control when used with compatible Z-Wave controller or Eaton’s home automation hub
Security
As a Z-Wave Plus certified product, Plug-In Module - ON/OFF supports Z-Wave S2 security. The following security modes are directly supported:
- S2 Authenticated
- S2 Unauthenticated
Features
Eaton describes Plug-In Module - ON/OFF as having the following features:
- Z-Wave Scene Type
- Color
- Firmware updatable via a compatible Z-Wave gateway
- Switch Load Capacity Watts
- Loads Controlled
- Supported Notification Types
- Electric Load Type
- Switch Load Capacity Current
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
This ON/OFF plug supports Auto Inclusion feature where it will automatically enter Inclusion mode when first powered up after a factory reset.
1. There is an ON/OFF button on the front of the device which is used to carry out inclusion, exclusion or association.
2. Put your Z-Wave Controller into inclusion/exclusion mode.
3. Plug this ON/OFF Plug-in module into a wall outlet near the load to be controlled.
4. The Inclusion process should be completed when the LED stops blinking.
Note: If Auto Inclusion fails, refer to the Troubleshooting section regarding Manual Inclusion
If auto inclusion fails:
1. Put the Z-Wave Controller into Inclusion mode
2. Press the ON/OFF button 3 times within
1.5 seconds to put the unit into Inclusion mode
1. Put the Z-Wave Controller into Exclusion mode
2. Press the ON/OFF button 3 times within
1.5 seconds to put the unit into Exclusion mode
Factory reset Plug-In Module - ON/OFF
Please use this procedure only when the network primary controller is missing or otherwise inoperable
1. Press the ON/OFF button 3 times within
1.5 seconds to put the unit into exclusion mode
2. Within 1 second of step 1, press and hold the
button for 5 seconds
3. Node ID is deleted. The device reverts to factory
default state
Please note that this is a user manual Plug-In Module - ON/OFF from Eaton is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Plug-In Module - ON/OFF and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.