Categories

Aeotec

Atrim

SmartThings

Z-Wave Products

MultiSensor 6 (ZW100-G) manual for Z-Wave

The following is an overview of the user manual for the Z-Wave product MultiSensor 6 (ZW100-G)from ECO LIFE ENGINEERING. To view other Z-Wave products and manuals from Eco Life Engineering follow that link.

  1. Overview
  2. Security
  3. Features
  4. Installation instructions

Overview

Name
MultiSensor 6
SKU Code
ZW100-G
Description
ECO LIFE ENGINEERING MultiSensor 6 looks like a motion sensor and it acts like one too. But it’s also so much more. Installing this 1 piece of Z-Wave® technology is the same as installing 6 pieces of Z-Wave technology. Your home control network will immediately understand motion, temperature, humidity, light, Ultraviolet and Vibration readings wherever MultiSensor installed. Those intelligent readings will equate to intelligence automation. And intelligent automation will give you the perfect, smart home.
Version #
HW: 100 FW: 1.10 was the version certified
Certification #
ZC10-18025990
Certified
2018-02-07T04:00:04.265625
Z-Wave Version
6.51.10

Security

As a Z-Wave Plus certified product, MultiSensor 6 supports Z-Wave S2 security. The following security modes are directly supported:

    Features

    Eco Life Engineering describes MultiSensor 6 as having the following features:

    • Battery powered using CR123A batteries
    • Firmware updatable via a compatible Z-Wave gateway
    • IP (Ingress Protection) Rated
    • Battery Quantity
    • Sensors
    • Supported Notification Types
    • FLiRS capable
    • Supports Network Wide Inclusion
    • Supports Z-Wave Explorer Frames
    • Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via

    Installation instructions

    Turn the primary controller of Z-Wave network into inclusion mode, short press the product’s Z-Wave button that you can find in the back of the product.

    Turn the primary controller of Z-Wave network into exclusion mode, short press the product’s Z-Wave button that you can find in back of the product.

    Factory reset MultiSensor 6

    Press and hold the Z-Wave button that you can find in back of the product for 20 seconds and then release. This procedure should only be used when the primary controller is inoperable.

    Pressing the Z-Wave button once will trigger sending the Wake up notification command. If press and hold the Z-Wave button for 3 seconds, the MultiSensor will wake up for 10 minutes.

    Support ""Over the Air Firmware Updating"" and “Z-Wave Security”.

    Please note that this is a user manual MultiSensor 6 from ECO LIFE ENGINEERING is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have MultiSensor 6 and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.