Single Function Magnetic Sensor (PSM08-3E) manual for Z-Wave

The following is an overview of the user manual for the Z-Wave product Single Function Magnetic Sensor (PSM08-3E)from ECO LIFE ENGINEERING. To view other Z-Wave products and manuals from Eco Life Engineering follow that link.

  1. Overview
  2. Security
  3. Features
  4. Installation instructions


Single Function Magnetic Sensor
SKU Code
The door/window sensor PSM08 has door/window sensor function,based on Z-Wave™ technology.
Version #
HW: 1 FW: 1.02 was the version certified
Certification #
Z-Wave Version


As a Z-Wave Plus certified product, Single Function Magnetic Sensor supports Z-Wave S2 security. The following security modes are directly supported:


    Eco Life Engineering describes Single Function Magnetic Sensor as having the following features:

    • Battery Quantity
    • Battery powered using CR123A batteries
    • Sensors
    • Supported Notification Types
    • FLiRS capable
    • Supports Network Wide Inclusion
    • Supports Z-Wave Explorer Frames
    • Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via

    Installation instructions

    There is a button on PSM08.
    1. Have Z-Wave™ Controller entered inclusion mode.
    2. Pressing button once to enter the inclusion mode.
    3. After add successful, the device will wake to receive the setting command from Z-Wave™ Controller about 20 seconds.

    There is a button on PSM08.
    1. Have Z-Wave™ Controller entered exclusion mode.
    2. Pressing button once to enter the exclusion mode.

    There is a button on PSM08.
    Press the button once, the device will awake 10 seconds.

    Factory reset Single Function Magnetic Sensor

    There is a button on PSM08.
    1. Pressing button for about 5 seconds.
    2. IDs are excluded and all settings will reset to factory default.
    Notice: Use this procedure only in the event that the primary controller is lost or otherwise inoperable.

    Please note that this is a user manual Single Function Magnetic Sensor from ECO LIFE ENGINEERING is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. only warrants and is only able to support products purchased directly from us. If you have Single Function Magnetic Sensor and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.