The following is an overview of the user manual for the Z-Wave product 700 Series Garage Door Controller (GDZW7-ECO)from Ecolink. To view other Z-Wave products and manuals from Ecolink follow that link.
Overview
Security
As a Z-Wave Plus certified product, 700 Series Garage Door Controller supports Z-Wave S2 security. The following security modes are directly supported:
- S2 Access Control
Features
Ecolink describes 700 Series Garage Door Controller as having the following features:
- Firmware updatable via a compatible Z-Wave gateway
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
1. Follow the instructions of the Z-Wave controller to put the Z-Wave controller into manual or classic Z-Wave inclusion mode.
2. Locate and press the hub button on the device.
3. When it is successfully added, the device will beep and blink green once.
1. Follow the Z-Wave controller’s instructions on putting the Z-Wave controller into removal/exclusion mode.
2. Locate and press the hub button.
3. Device’s status indicator will blink red and beep three times to indicate successful removal.
Factory reset 700 Series Garage Door Controller
Hold the reset button down for ten seconds. The status indicator will blink red while the reset button is pressed and will go out after ten seconds.
The device’s status indicator will turn green when the reset operation is complete.
SmartStart location
SmartStart QR code's location as follows: On the back of the device.
Please note that this is a user manual 700 Series Garage Door Controller from Ecolink is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have 700 Series Garage Door Controller and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.