The following is an overview of the user manual for the Z-Wave product Chime+Siren (ISZW7-ECO)from Ecolink. To view other Z-Wave products and manuals from Ecolink follow that link.
Overview
This easy to install Security siren has 30 different build in sound effects for different notifications and sirens.
It has a built in 24 hour battery back up in case of power outages or when used in a security system to prevent tampering to turn sirens off.
It has a microSD slot to allow custom sounds to be loaded onto the device.
Security
As a Z-Wave Plus certified product, Chime+Siren supports Z-Wave S2 security. The following security modes are directly supported:
- S2 Authenticated
- S2 Unauthenticated
Features
Ecolink describes Chime+Siren as having the following features:
- Color
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
the device is awake. It can receive commands all the time.
SmartStart location
SmartStart QR code's location as follows: Page 1 of advanced operational manual. Instruction set #2 on the product setup guide.
Adding to a Z-Wave Network (Classic Inclusion Method)
Make sure the device has power. Press the Pair Button which is the smaller of the two buttons, and the device will enter classic inclusion mode which implements both classic inclusion with a Node Information Frame, and Network Wide Inclusion. During Classic Inclusion mode, the Green LED will blink two times every three seconds. When Classic inclusion times-out, the device will blink red and green.
Removing a Sensor from a Z-Wave Network
To remove the device, place the controller into Remove or “Z-Wave Exclusion” mode. Press the smaller of the two buttons (Add/Test) following the same procedure to add for removal. Upon successful removal, the device’s red led will come on solid for 1 second. Note: Any Z-Wave Inclusion Controller can remove a Z-Wave device regardless of manufacturer or which network the device is currently added to.
Factory reset Chime+Siren
Factory Default
Please use this procedure only when the network primary controller is missing or otherwise inoperable.
To restore the device back to factory settings and remove it from any Z-Wave network. Hold the Pair button for 10 seconds. During the 10 seconds of continuing to hold the Add/Test button the green LED with flash, and after 10 seconds the red LED will come on solid for 1 second indicating that the factory default of the device has been successful, and the device is ready to add back into a Z-Wave network.
Please note that this is a user manual Chime+Siren from Ecolink is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Chime+Siren and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.