The following is an overview of the user manual for the Z-Wave product Eu Z-wave Door Window Sensor (H114101)from Ecolink Intelligent Technology. To view other Z-Wave products and manuals from Ecolink follow that link.
Overview
Sleek design virtually disappears
Easy-to-open case requires no special tools
Case tamper protection
Ideal for double-hung window
Up to 3 year battery life on 1 CR123A lithium battery
Uses rare earth magnet for up to 5/8th inch gap detection
Includes white and brown cases
Security
As a Z-Wave Plus certified product, Eu Z-wave Door Window Sensor supports Z-Wave S2 security. The following security modes are directly supported:
Features
Ecolink describes Eu Z-wave Door Window Sensor as having the following features:
- Sensors
- Supported Notification Types
- Battery Quantity
- Battery powered using CR123A batteries
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
Includes external contacts for wiring.
Factory reset Eu Z-wave Door Window Sensor
To restore this sensor to factory default settings, follow the instructions in this manual to exclude this sensor from the Z-Wave network. Upon completion of removal from the network the sensor will restore itself to factory default settings automatically. Use this procedure only in the event that the network primary controller is missing or otherwise inoperable.
Exclusion mode on the senor is initiated following the same exact procedure as inclusion.
The sensor will wake up every so often and when the case is closed to send a Wake-Up Notification to allow the life line master node controller that the sensor is now available for any queued messages that the controller may have for the sensor. The time between Wake-Up Notifications can be configured with the Wake-Up Notification command class to be between 1 hour and 1 week with interval steps of 200 seconds.
The sensor must be added to a Z-Wave network prior to use. To include the sensor in a network both the sensor and the network controller must be in inclusion mode at the same time. Refer to the instructions provided by the manufacturer of your specific controller for details on initiating the controller’s inclusion mode.
STEP ONE Start by placing the controller into inclusion mode.
STEP TWO Activate inclusion mode for the sensor by removing the plastic pull-tab from the back of the sensor. When the
inclusion process is complete, the LED on the sensor will be solid blue, then go out.
STEP THREE Test the sensor. Place the magnet next to the sensor to represent a closed position (see Installation section
to see where to position the magnet). If the LED flashes ONE TIME, it is successfully communicating on your
Zwave network. If the LED on the sensor flashes slow and steady for 5 seconds, you need to repeat the
inclusion process.
Please note that this is a user manual Eu Z-wave Door Window Sensor from Ecolink Intelligent Technology is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Eu Z-wave Door Window Sensor and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.