The following is an overview of the user manual for the Z-Wave product Eu Z-wave Flood Freeze Sensor (H214104)from Ecolink Intelligent Technology. To view other Z-Wave products and manuals from Ecolink follow that link.
Overview
Product Overview
-Z-Wave Plus enabled device which detects flood and freeze.
-Reports tamper condition when cover is open.
Product Specifications
-For indoor use only
-Operating frequency: 868.2 MHz
-Operating temperature: 0° – 49°C, 32° – 120°F (ambient temperature)
-Operating humidity 5-95% non-condensing
-Battery type required: 3V Lithium CR123A
-Battery life approximately 5 years
Security
As a Z-Wave Plus certified product, Eu Z-wave Flood Freeze Sensor supports Z-Wave S2 security. The following security modes are directly supported:
Features
Ecolink describes Eu Z-wave Flood Freeze Sensor as having the following features:
- Supported Notification Types
- Battery Quantity
- Battery powered using CR123A batteries
- Color
- Sensors
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
1) Any sensor can be removed from any Z-Wave Plus controller. Follow the directions to put your Z-Wave Plus Controller into exclusion mode. Please use this procedure only when the network primary controller is missing or otherwise inoperable.
2) Open the Flood Freeze case and remove the battery for 1 seconds. Replace the battery and the controller should remove the device from the Z-Wave network.
Factory reset Eu Z-wave Flood Freeze Sensor
The Flood Freeze sensor factory defaults on network exclusion. Please use this procedure only when the network primary controller is missing or otherwise inoperable."" - You may use wording of your own choosing as long as it effectively means the same thing
This device is asleep most of the time but can respond to queries on a Wake Up Notification; however for test purposes, the device will stay awake while tampered for testing Z-Wave Plus command class functionality.
The sensor must be added to a Z-Wave network prior to use. To include the sensor in a network both the sensor and the network controller must be in inclusion mode at the same time. Refer to the instructions provided by the manufacturer of your specific controller for details on initiating the controller’s inclusion mode.
1) Verify that the Z-Wave Plus controller you are using is compatible with the Flood Freeze sensor.
2) Either mount or move the Flood Freeze sensor as close as possible to the location the sensor will remain. See installation section below.
3) Put your Z-Wave Plus Controller into add (inclusion) mode.
4) To add the sensor to an existing Z-Wave network, follow the directions to put your Z-Wave Controller into add (inclusion) mode. The Flood Freeze enters add and remove (inclusion/exclusion) when powered on (when battery is added). If the LED starts blinking continuously, the sensor has no node ID and was not successfully added, so start step C over again. Make sure to remove the battery for 10 seconds if adding to a Z-Wave network fails.
5) If after 5 seconds the LED is not blinking, look on the Z-Wave controller’s interface for feedback on whether the sensor was added successfully. If you do not see any feedback that the sensor was added, follow directions for removing the sensor from a Z-Wave network, and then try adding the sensor again. If you are still having problems, you may need to add additional Z-Wave listening devices in-between the controller and the sensor.
Please note that this is a user manual Eu Z-wave Flood Freeze Sensor from Ecolink Intelligent Technology is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Eu Z-wave Flood Freeze Sensor and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.