The following is an overview of the user manual for the Z-Wave product Eu Z-wave Pir Motion Sensor (H214101)from Ecolink Intelligent Technology. To view other Z-Wave products and manuals from Ecolink follow that link.
Overview
• Operating frequency: 908.42 MHz
• Operating range: Up to 100 feet (30.5 meters) line-of-sight
• Operating temperature: 0˚C to 49˚C, 32˚F to 120˚F (ambient temperature)
• Detection radius: 39 feet (see detection region diagram)
• Detection angle: 45 degrees in either direction from the sensor’s center
• Battery type: 3V Lithium CR123A
• Battery life: approximately 3 years
• Passive Infrared (PIR) based technology
Security
As a Z-Wave Plus certified product, Eu Z-wave Pir Motion Sensor supports Z-Wave S2 security. The following security modes are directly supported:
Features
Ecolink describes Eu Z-wave Pir Motion Sensor as having the following features:
- Color
- Battery powered using CR123A batteries
- Supported Notification Types
- Battery Quantity
- Sensors
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
The sensor must be added to a Z-Wave network prior to use. To include the sensor in a network, both the sensor and the network controller must be in inclusion mode at the same time.
Activate inclusion mode for the sensor by removing the battery isolation pull tab, or by inserting the battery (see next section for battery installation tips). When the inclusion process is complete the red LED will turn on for approximately 10 seconds and then it will go out. If the LED continues to flash repeat the inclusion process.
Refer to the instructions provided by the manufacturer of your specific controller for details on initiating the controller’s inclusion mode.
STEP ONE Start by placing the controller into inclusion mode.
STEP TWO Activate inclusion mode for the sensor by removing the battery isolation pull tab, or by inserting the battery (see next section for battery installation tips). When the inclusion process is complete the red LED will turn on for approximately 10 seconds and then it will go out. If the LED continues to flash repeat the inclusion process.
STEP THREE Test the motion sensor before mounting it. Place the sensor in an unoccupied room. Leave the room for at least 4 minutes. Return to the room and pass in front of the sensor lens. The LED will flash once to indicate that motion was detected.
Exclusion mode on the sensor is initiated following the same exact procedure as inclusion.
To save power, this sensor sleeps most of the time and is therefore not awake to receive messages from a gateway for testing. Removing the top case from the sensor will put in device into a tampered mode in which the sensor will stay awake and able to receive messages. Most of the time an end user would not do this, but if the sensor needs to be configured after inclusion, an end user can follow the instructions below for sending Wake-Up notifications.
Factory reset Eu Z-wave Pir Motion Sensor
To restore this sensor to factory default settings, follow the instructions in this manual to exclude this sensor from the Z-Wave network. Upon completion of removal from the network the sensor will restore itself to factory default settings automatically. Use this procedure only in the event that the network primary controller is missing or otherwise inoperable.
Please note that this is a user manual Eu Z-wave Pir Motion Sensor from Ecolink Intelligent Technology is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Eu Z-wave Pir Motion Sensor and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.