The following is an overview of the user manual for the Z-Wave product Garage Door Tilt Sensor (TILTZWAVE2.5-ECO)from Ecolink Intelligent Technology. To view other Z-Wave products and manuals from Ecolink follow that link.
Overview
• Operating frequency: 908.42 MHz
• Operating range: Up to 100 feet (30.5 meters) line-of-sight
• Operating temperature: 0˚C to 49˚C, 32˚F to 120˚F (ambient temperature)
• Battery type: 3V Lithium CR123A
• Battery life: 5 to 8 years depending upon operating conditions
Security
As a Z-Wave Plus certified product, Garage Door Tilt Sensor supports Z-Wave S2 security. The following security modes are directly supported:
Features
Ecolink describes Garage Door Tilt Sensor as having the following features:
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
Once the controller is in inclusion mode, remove the battery pull tab OR insert the battery to power up the sensor.
Once the controller is in exclusion mode, remove the battery pull tab OR insert the battery into the sensor to initiate power up.
Factory reset Garage Door Tilt Sensor
To reset the sensor to factory default, place the controller in exclusion mode and then insert the battery into the sensor to initiate power up. Use this procedure only in the event that the network primary controller is missing or otherwise inoperable.
Simply remove the sensor cover to wake up for configuration.
Please note that this is a user manual Garage Door Tilt Sensor from Ecolink Intelligent Technology is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Garage Door Tilt Sensor and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.