The following is an overview of the user manual for the Z-Wave product Motion Detector (PIRZWAVE2.5-ECO)from Ecolink Intelligent Technology. To view other Z-Wave products and manuals from Ecolink follow that link.
Overview
• Operating frequency: 908.42 MHz
• Operating range: Up to 100 feet (30.5 meters) line-of-sight
• Operating temperature: 0˚C to 49˚C, 32˚F to 120˚F (ambient temperature)
• Detection radius: 39 feet (see detection region diagram)
• Detection angle: 45 degrees in either direction from the sensor’s center
• Battery type: 3V Lithium CR123A
• Battery life: approximately 3 years
• Passive Infrared (PIR) based technology
Security
As a Z-Wave Plus certified product, Motion Detector supports Z-Wave S2 security. The following security modes are directly supported:
Features
Ecolink describes Motion Detector as having the following features:
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
Once the controller is in inclusion mode, simply remove the battery isolation tab, OR insert the battery, OR press the small button on the back of the Motion Detector.
Once the controller is in exclusion mode, simply remove the battery isolation tab, OR insert the battery, OR press the small button on the back of the Motion Detector.
Factory reset Motion Detector
To restore this sensor to factory default settings, follow the instructions for product exclusion which will reset the sensor upon completion of the process. Use this procedure only in the event that the network primary controller is missing or otherwise inoperable.
If the sensor is asleep, simply remove the cover to wake up the sensor for configuration.
Please note that this is a user manual Motion Detector from Ecolink Intelligent Technology is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Motion Detector and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.