The following is an overview of the user manual for the Z-Wave product Z-Wave Plus Garage Door Tilt Sensor (TILT-ZWAVE5)from Ecolink Intelligent Technology. To view other Z-Wave products and manuals from Ecolink follow that link.
Overview
Security
As a Z-Wave Plus certified product, Z-Wave Plus Garage Door Tilt Sensor supports Z-Wave S2 security. The following security modes are directly supported:
- S2 Authenticated
- S2 Unauthenticated
Features
Ecolink describes Z-Wave Plus Garage Door Tilt Sensor as having the following features:
- Communications Protocol
- Color
- Communications Connections
- Battery Quantity
- Firmware updatable via a compatible Z-Wave gateway
- Battery powered using batteries
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
SmartStart location
SmartStart QR code's location as follows: The DSK is below the QR code on the plastic case of the product.
Unable to access the DSK via the UI.
DSK also comes with insert in product packaging.
Network Inclusion
The Z-Wave Plus Garage Tilt Sensor must be added to a Z-Wave Plus network prior to use. To include the device in a network both the device and the network controller must be in inclusion mode at the same time. Refer to the instructions provided by the manufacturer of your specific controller for details on initiating the controller’s inclusion mode.
1) Verify that the Z-Wave Plus controller you are using is compatible with the Z-Wave Plus Tilt Sensor.
2) Put your Z-Wave Plus Controller into add (inclusion) mode.
3) Insert the battery and press the learn button on the tilt sensor.
4) The LED on the front of the unit will turn off if network inclusion is successful.
Network Exclusion
1) Any Z-Wave Plus Device can be removed from any Z-Wave Plus controller. Follow the directions to put your Z-Wave Plus Controller into exclusion mode.
2) Press the inclusion / exclusion button on the Z-Wave Plus Tilt Sensor.
3) The LED in front of the unit will blink steadily if the network exclusion is successful.Notes:
• Controller inclusion mode must be activated BEFORE starting sensor inclusion or exclusion mode.
• The device can only be included into one controller network at a time, and must be excluded from one network before inclusion in another.
Wake up notification is tampering the case / opening the case
Factory reset Z-Wave Plus Garage Door Tilt Sensor
Factory Default
The Z-Wave Plus Tilt Sensor can be factory defaulted by pressing and holding the factory reset button for 5 seconds.
Please note that this is a user manual Z-Wave Plus Garage Door Tilt Sensor from Ecolink Intelligent Technology is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Z-Wave Plus Garage Door Tilt Sensor and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.