The following is an overview of the user manual for the Z-Wave product Z-Wave Plus Single Gang Decora Wireless Light Switch (DLS-ZWAVE5)from Ecolink Intelligent Technology. To view other Z-Wave products and manuals from Ecolink follow that link.
Overview
Product Specifications:
• For indoor use only
• Operating frequency: 908.42 MHz
• Operating temperature: 0° – 49°C, 32° – 120°F (ambient temperature)
• Operating humidity 5-95% non-condensing
• 2 AA batteries
• Battery Life: Approximatly 1 year
Security
As a Z-Wave Plus certified product, Z-Wave Plus Single Gang Decora Wireless Light Switch supports Z-Wave S2 security. The following security modes are directly supported:
Features
Ecolink describes Z-Wave Plus Single Gang Decora Wireless Light Switch as having the following features:
- Color
- Battery Quantity
- Battery powered using AA, Alkaline batteries
- Switch Type
- Firmware updatable via a compatible Z-Wave gateway
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
1) Any Z-Wave Plus Device can be removed from any Z-Wave Plus controller. Follow the directions to put your Z-Wave Plus Controller into exclusion mode.
2) Press the inclusion / exclusion button on the Z-Wave Plus Decora Light Switch.
The Z-Wave Plus Decora Light Switch must be added to a Z-Wave Plus network prior to use. To include the device in a network both the device and the network controller must be in inclusion mode at the same time. Refer to the instructions provided by the manufacturer of your specific controller for details on initiating the controller’s inclusion mode.
1) Verify that the Z-Wave Plus controller you are using is compatible with the Z-Wave Plus Decora Light Switch.
2) Locate the light switch desired to be used with the Z-Wave Plus Decora Light Switch.
3) Put your Z-Wave Plus Controller into add (inclusion) mode.
4) Press the inclusion button on the Z-Wave Plus Decora Light Switch. (Figure 1)
5) The LED on the front of the unit will turn off if successfully included into a network.
Factory reset Z-Wave Plus Single Gang Decora Wireless Light Switch
The Z-Wave Plus device is automatically factory defaulted when removed from a Z-Wave Plus network. Please use this procedure only when the network primary controller is missing or otherwise inoperable.
Please note that this is a user manual Z-Wave Plus Single Gang Decora Wireless Light Switch from Ecolink Intelligent Technology is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Z-Wave Plus Single Gang Decora Wireless Light Switch and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.