The following is an overview of the user manual for the Z-Wave product Z-Wave Plus Smart Switch - Double Toggle (DTLS2-ZWAVE5)from Ecolink Intelligent Technology. To view other Z-Wave products and manuals from Ecolink follow that link.
Overview
Features
Quick installation, no need to access high voltage wires
Compatible with all Z-wave certified hubs & controllers
Preserves manual control of switch
Senses current status of switch
Works with Dual gang Toggle type switches
Security
As a Z-Wave Plus certified product, Z-Wave Plus Smart Switch - Double Toggle supports Z-Wave S2 security. The following security modes are directly supported:
Features
Ecolink describes Z-Wave Plus Smart Switch - Double Toggle as having the following features:
- Battery Quantity
- Battery powered using AA batteries
- Color
- Sensors
- Switch Type
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
1) Any Z-Wave Plus Device can be removed from any Z-Wave Plus controller. Follow the directions to put your Z-Wave Plus Controller into exclusion mode.
2) Press the inclusion / exclusion button on the Z-Wave Plus Smart Switch.
3) The LED in front of the unit will blink steadily if the network exclusion is successful.
The Z-Wave Plus Smart Switch must be added to a Z-Wave Plus network prior to use. To include the device in a network both the device and the network controller must be in inclusion mode at the same time. Refer to the instructions provided by the manufacturer of your specific controller for details on initiating the controller’s inclusion mode.
1) Verify that the Z-Wave Plus controller you are using is compatible with the Z-Wave Plus Smart Switch.
2) Put your Z-Wave Plus Controller into add (inclusion) mode.
3) Press the inclusion / exclusion button on the Z-Wave Plus Smart Switch.
4) The LED on the front of the unit will turn off if network inclusion is successful.
Factory reset Z-Wave Plus Smart Switch - Double Toggle
The Z-Wave Plus device is automatically factory defaulted when removed from a Z-Wave Plus network. Please use this procedure only when the network primary controller is missing or otherwise inoperable.
Please note that this is a user manual Z-Wave Plus Smart Switch - Double Toggle from Ecolink Intelligent Technology is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Z-Wave Plus Smart Switch - Double Toggle and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.