The following is an overview of the user manual for the Z-Wave product Z-Wave Plus Wireless Siren (SC-ZWAVE5)from Ecolink Intelligent Technology. To view other Z-Wave products and manuals from Ecolink follow that link.
Overview
The device can create 4 independent tones for different alerts to the user. These could include but are not limited to: Security Alarm, entry/exit, smoke/Fire, temperature and more. The Z-Wave Plus Siren can also be used as a Z-Wave Plus network extension.
Security
As a Z-Wave Plus certified product, Z-Wave Plus Wireless Siren supports Z-Wave S2 security. The following security modes are directly supported:
Features
Ecolink describes Z-Wave Plus Wireless Siren as having the following features:
- Communications Protocol
- Switch Load Capacity Current
- Switch Load Capacity Volt-Ampere
- Switch Load Capacity Watts
- Switch Type
- Z-Wave Scene Type
- Color
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
Factory reset Z-Wave Plus Wireless Siren
The Z-Wave Plus Siren is automatically factory defaulted when removed from a Z-Wave network. Please use this procedure only when the network primary controller is missing or otherwise inoperable.
1) Any Z-Wave Plus Device can be removed from any Z-Wave Plus controller. Follow the directions to put your Z-Wave Plus Controller into exclusion mode.
2) Unplug and re-plug in your Z-Wave Plus Siren.
3) The device will play a long beep and the LED will begin to breathe if the device is successfully removed from the network.
The Z-Wave Plus Siren must be added to a Z-Wave network prior to use. To include the siren in a network both the siren and the network controller must be in inclusion mode at the same time. Refer to the instructions provided by the manufacturer of your specific controller for details on initiating the controller’s inclusion mode.
1) Verify that the Z-Wave Plus controller you are using is compatible with the Z-Wave Plus Siren.
2) Locate the power outlet desired to be used with the Z-Wave Plus Siren.
3) Put your Z-Wave Plus Controller into add (inclusion) mode.
4) Plug in the Z-Wave Siren and verify a single beep sound is heard.
5) The LED on the front of the unit will turn off if successful included into a network.
Please note that this is a user manual Z-Wave Plus Wireless Siren from Ecolink Intelligent Technology is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Z-Wave Plus Wireless Siren and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.