The following is an overview of the user manual for the Z-Wave product Evc200 (EVC200)from EcoNet Controls . To view other Z-Wave products and manuals from EcoNet Controls follow that link.
Overview
Security
As a Z-Wave Plus certified product, Evc200 supports Z-Wave S2 security. The following security modes are directly supported:
Features
EcoNet Controls describes Evc200 as having the following features:
- Switch Type
- Outdoor Use
- Color
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
Not applicable
Factory reset Evc200
Press and hold the Button for 10 seconds to perform Local Reset procedure. Please use this procedure only when the network primary controller is missing or otherwise inoperable.”
Press Button on the Valve-Control-Box three times rapidly (three times within 1.5 seconds). The red LED light will start blinking immediately (1 blink per second)
Press Button on the Valve-Control-Box three times rapidly (three times within 1.5 seconds). The red LED light will start blinking immediately (1 blink per second)
Please note that this is a user manual Evc200 from EcoNet Controls is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Evc200 and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.