Categories

Aeotec

Atrim

SmartThings

Z-Wave Products

Flood leak sensor (EZW1204) manual for Z-Wave

The following is an overview of the user manual for the Z-Wave product Flood leak sensor (EZW1204)from EcoNet Controls . To view other Z-Wave products and manuals from EcoNet Controls follow that link.

  1. Overview
  2. Security
  3. Features
  4. Installation instructions

Overview

Name
Flood leak sensor
SKU Code
EZW1204
Description
EcoNet's Leak/Flood Sensor is compatible with most popular Smart Home systems including Samsung's SmartThings, Wink, Vera and Homeseer. After included/paired and Smart Home automated, simply place the Leak Sensor on the floor in the laundry room, bathroom or any water sensitive area to receive leak notifications to your smart phone. Add EcoNet's Valve Robot for Automatic water shut off in the case of a leak. The sensor can also be wall mounted using the included snap-in base with the wired leak tab.
Version #
HW: 1 FW: 1.01 was the version certified
Certification #
ZC10-18015939
Certified
2018-01-05T17:07:20.603281
Z-Wave Version
6.71.01

Security

As a Z-Wave Plus certified product, Flood leak sensor supports Z-Wave S2 security. The following security modes are directly supported:

  • S2 Unauthenticated

Features

EcoNet Controls describes Flood leak sensor as having the following features:

  • Firmware updatable via a compatible Z-Wave gateway
  • Sensors
  • Supported Notification Types
  • Battery Quantity
  • Battery powered using AAA batteries
  • Color
  • FLiRS capable
  • Supports Network Wide Inclusion
  • Supports Z-Wave Explorer Frames
  • Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via

Installation instructions

1. Follow the instructions for your Z-Wave certified controller to include a device to the Z-Wave network.
2. Once the controller is ready to include your device, press up and release the toggle to include it in the network.
3. Once your controller has confirmed that the device has been included, refresh the Z-Wave network to optimize performance.
4. The device is associated in the same group when it included in setting process.
Now you can control your Z-Wave device according to groups, scenes, schedules and automation programmed.

1. Follow the instructions for your Z-Wave certified controller to exclude a device from the Z-Wave network.
2. Once the controller is ready to Exclude your device, press up and release the toggle to exclude it from the network.

Factory reset Flood leak sensor

Please use this procedure only when the network primary controller is missing or otherwise inoperable.

Open the shell, wake up immediately

Please note that this is a user manual Flood leak sensor from EcoNet Controls is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Flood leak sensor and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.