The following is an overview of the user manual for the Z-Wave product eedomus (eedomus+)from eedomus. To view other Z-Wave products and manuals from eedomus follow that link.
Overview
Control your home from the eedomus app or any web browser by connecting to your secure account.
Security
As a Z-Wave Plus certified product, eedomus supports Z-Wave S2 security. The following security modes are directly supported:
- S2 Access Control
- S2 Authenticated
- S2 Unauthenticated
Features
eedomus describes eedomus as having the following features:
- Communications Connections
- Communications Protocol
- Gateway Has Preferred Partners
- Firmware updatable via a compatible Z-Wave gateway
- Color
- Sensors
- Supported Notification Types
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
To add a Z-Wave device to the network, click on :
Configuration / Add or remove a device / Add a Z-Wave device
The eedomus controller will attempt to include the new node during 1 minute.
Then press the button on the Z-Wave device to be added (Refer to device manual, activation of the inclusion may differ from device to device)
To remove a Z-Wave device from the network, click on :
Configuration / Add or remove a device / Remove a Z-Wave device
The eedomus controller will attempt to exclude the new node during 1 minute.
Then press the button on the Z-Wave device to be removed (Refer to device manual, activation of the exclusion may differ from device to device)
Learn Mode is used to receive network information from another controller (When including the eedomus controller on an existing network for example).
To start the Learn Mode on the eedomus controller, click on :
Configuration / Add or remove a device / Advanced Z-Wave function / Learn mode
To include the eedomus controller on an existing network, start the inclusion process on the existing network controller (Refer to controller manual) then start learn mode on your eedomus controller.
Factory reset eedomus
You can proceed to a Z-Wave chip factory reset in order to do a fresh installation of your network.
When doing that the Home ID of your network will change and your devices need to be excluded (In order to be reseted) and included again.
To perform a factory reset, click on :
Configuration / Add or remove a device / Advanced Z-Wave functions / Reset Z-Wave controller
If this controller is the primary controller for your network, resetting it will result in the nodes in your network being orphaned and it will be necessary after the reset to exclude and re-include all of the nodes in the network.
If this controller is being used as a secondary controller in the network, use this procedure to reset this controller only in the event that the network primary controller is missing or otherwise inoperable.
Please note that this is a user manual eedomus from eedomus is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have eedomus and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.