Z-Wave Carbon Monoxide Alarm (EiA207DRFZ) manual for Z-Wave

The following is an overview of the user manual for the Z-Wave product Z-Wave Carbon Monoxide Alarm (EiA207DRFZ)from Ei Electronics. To view other Z-Wave products and manuals from Ei Electronics follow that link.

  1. Overview
  2. Security
  3. Features
  4. Installation instructions


Z-Wave Carbon Monoxide Alarm
SKU Code
This premium quality electrochemical Carbon Monoxide Alarm designed to North American standards with plug-in Z-Wave Communication Module provides a 10 year sensor life, LCD Display and is powered by two replaceable AAA batteries.

The CO Sensor is monitored electronically and will report the following:
1. Alarm on Sensing Carbon Monoxide
2. Battery status reporting
3. Sensor Fault
4. Alarm removal from mounting plate
5. Sensor End of Life
The device is a secure Z-Wave Plus device and can be used in one wireless Z-Wave network with other Z-Wave certified devices.
Version #
HW: 1 FW: 1.00 was the version certified
Certification #
Z-Wave Version


As a Z-Wave Plus certified product, Z-Wave Carbon Monoxide Alarm supports Z-Wave S2 security. The following security modes are directly supported:


    Ei Electronics describes Z-Wave Carbon Monoxide Alarm as having the following features:

    • Battery Quantity
    • Battery powered using AAA batteries
    • Color
    • Sensors
    • FLiRS capable
    • Supports Network Wide Inclusion
    • Supports Z-Wave Explorer Frames
    • Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via

    Installation instructions

    Pressing the button 'Inclusion Button' for one second will include the device. If the button is pressed for at least 2 seconds the inclusion will be done without the Security Command Class.

    A single click on the button will exclude the device.

    Factory reset Z-Wave Carbon Monoxide Alarm

    To do a factory reset press the button on the bottom of the device for at least 10 seconds. This procedure should only be used when the primary controller is inoperable.

    A single click on the button will wakeup the device.

    Please note that this is a user manual Z-Wave Carbon Monoxide Alarm from Ei Electronics is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Z-Wave Carbon Monoxide Alarm and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.