Z-Wave Carbon Monoxide Alarm (EiA207RFZ) manual for Z-Wave

The following is an overview of the user manual for the Z-Wave product Z-Wave Carbon Monoxide Alarm (EiA207RFZ)from Ei Electronics. To view other Z-Wave products and manuals from Ei Electronics follow that link.

  1. Overview
  2. Security
  3. Features
  4. Installation instructions


Z-Wave Carbon Monoxide Alarm
SKU Code
This premium quality electrochemical Carbon Monoxide Alarm designed to North American standards with plug-in Z-Wave Communication Module provides a 10 year sensor life and is powered by two replaceable AAA batteries.

The CO Sensor is monitored electronically and will report the following:
1. Alarm on Sensing Carbon Monoxide
2. Battery status reporting
3. Sensor Fault
4. Alarm removal from mounting plate
5. Sensor End of Life
The device is a secure Z-Wave Plus device and can be used in one wireless Z-Wave network with other Z-Wave certified devices.
Version #
HW: 1 FW: 1.00 was the version certified
Certification #
Z-Wave Version


As a Z-Wave Plus certified product, Z-Wave Carbon Monoxide Alarm supports Z-Wave S2 security. The following security modes are directly supported:


    Ei Electronics describes Z-Wave Carbon Monoxide Alarm as having the following features:

    • Color
    • Sensors
    • Battery Quantity
    • Battery powered using AAA batteries
    • FLiRS capable
    • Supports Network Wide Inclusion
    • Supports Z-Wave Explorer Frames
    • Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via

    Installation instructions

    Factory reset Z-Wave Carbon Monoxide Alarm

    To do a factory reset press the button on the bottom of the device for at least 10 seconds. This procedure should only be used when the primary controller is inoperable.

    A single click on the button will wakeup the device.

    Pressing the button 'Inclusion Button' for one second will include the device. If the button is pressed for at least 2 seconds the inclusion will be done without the Security Command Class.

    A single click on the button will exclude the device.

    Please note that this is a user manual Z-Wave Carbon Monoxide Alarm from Ei Electronics is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Z-Wave Carbon Monoxide Alarm and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.