Z-Wave Photoelectric Smoke Alarm (EiA650RFZ) manual for Z-Wave

The following is an overview of the user manual for the Z-Wave product Z-Wave Photoelectric Smoke Alarm (EiA650RFZ)from Ei Electronics. To view other Z-Wave products and manuals from Ei Electronics follow that link.

  1. Overview
  2. Security
  3. Features
  4. Installation instructions


Z-Wave Photoelectric Smoke Alarm
SKU Code
This product consists of a premium quality Photoelectric Smoke Alarm designed to North American standards, combined with a plug-in Z-­Wave wireless communication module.
The Smoke Alarm will also function as a standalone device and is certified by Underwriters Laboratories and satisfies all UL217 requirements.
Patented, high-performance optical chamber with integral micro-mesh fixed insect screen further reduces the possibility of false alarms.
A large test button allows on-device test of smoke chamber, electronics and battery. The device also offers a built-­in self-test and an electronic smoke chamber test making the use of test aerosol unnecessary.
A low battery warning will last for 30 days, but full function of the Alarm will continue during this time.
The Z-Wave module allows the device to report smoke (EiA650RFZ) or to report smoke, as well as low battery alarms wirelessly to a central Z-Wave Controller.
Version #
HW: 1 FW: 1.02 was the version certified
Certification #
Z-Wave Version


As a Z-Wave Plus certified product, Z-Wave Photoelectric Smoke Alarm supports Z-Wave S2 security. The following security modes are directly supported:


    Ei Electronics describes Z-Wave Photoelectric Smoke Alarm as having the following features:

    • Sensors
    • Battery powered using CR123A batteries
    • Battery Quantity
    • FLiRS capable
    • Supports Network Wide Inclusion
    • Supports Z-Wave Explorer Frames
    • Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via

    Installation instructions

    To include the device start the inclusion on your controller and then hit the little button on the wireless module for 1 second

    To exclude the device start the inclusion on your controller and then hit the little button on the wireless module for 1 second

    Factory reset Z-Wave Photoelectric Smoke Alarm

    To reset the device keep the button pushed for 10 seconds. After 5 seconds the led starts flashing and after another 5
    seconds there is a short beep signaling the successful reset back to factory defaults. Use this procedure only when the network primary controller is missing or otherwise inoperable.

    Please note that this is a user manual Z-Wave Photoelectric Smoke Alarm from Ei Electronics is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Z-Wave Photoelectric Smoke Alarm and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.