The following is an overview of the user manual for the Z-Wave product System Controller (EL-SC-300)from Elan. To view other Z-Wave products and manuals from Elan follow that link.
Overview
Security
As a Z-Wave Plus certified product, System Controller supports Z-Wave S2 security. The following security modes are directly supported:
- S2 Access Control
- S2 Authenticated
- S2 Unauthenticated
Features
Elan describes System Controller as having the following features:
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
SmartStart location
SmartStart QR code's location as follows: Products are professionally installed. During configuration the UI will present the DSK information.
1. Navigation to the Communication Device: ELAN Z-Wave Network page under Security, Climate, Lighting or
Input/Output Tabs in Configurator 2. Management View: Network Management 3. Network Action: Learn 4.
Put other controller in Add/include mode per manufacturer instruction S. Execute {button to right of
Network action)
Replication of network information from the controller to another controller is not supported.
1. Navigation to the Communication Device: ELAN Z-Wave Network page under Security, Climate, Lighting or
Input/Output Tabs in Configurator 2. Management View: Network Provisioning. 3. Network Action: Remove
Device - This action removes the device only form the provisioning list & not from Z-wave network. 4.
Network Action: Clear List - This action removes all the devices only form the provisioning list & not from Z-Wave
network.
1. Navigation to the Communication Device: ELAN Z-Wave Network page under Security, Climate, Lighting or
Input/Output Tabs in Configurator 2. Set Management View: Network Management 3. Set Network Action:
Include 4. Put device in Inclusion/Learn mode per manufacturer instruction Execute {button to right of
Network action)
1. Navigation to the Communication Device: ELAN Z-Wave Network page under Security, Climate, Lighting or
Input/Output Tabs in Configurator 2. Management View: Network Management 3. Network Action: Exclude 4.
Put device in Exclusion/Learn mode per manufacturer instruction s. Execute {button to right of Network
action)
Factory reset System Controller
1. Navigation to the Communication Device: ELAN Z-Wave Network page under Security, Climate, Lighting or
Input/Output Tabs in Configurator 2. Management View: Network Management 3. Network Action: Reset 4.
Execute (button to right of Network action)
SmartStart installation
1. Navigation to the Communication Device: ELAN Z-Wave Network page under Security, Climate, Lighting or
Input/Output Tabs in Configurator 2. Management View: Network Provisioning. 3. Refer device
documentation/ manufacturer instruction for Z-Wave DSK of the device. 4. Put device full DSK string in
Device DSK text box & click Append. S. Click on "Add device to List " button. 6. Click on "Discover Devices
button" at the bottom. 7. Power on the end device or any other mechanism to start smart start in the device
to be added into SC300 network. Refer manufacturer instruction.
1. Navigation to the Communication Device: ELAN Z-Wave Network page under Security, Climate,
Lighting or Input/Output Tabs in Configurator
2. Management View: Network Management
3. Node Action: Request Info
4. Select desired Node ID in the Devices list
5. Execute (button to right of Node action)
Please note that this is a user manual System Controller from Elan is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have System Controller and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.