The following is an overview of the user manual for the Z-Wave product Dkc1001 (DKC1001)from Enblink. To view other Z-Wave products and manuals from Enblink follow that link.
Overview
It gives full control of connected Z-Wave devices.
Wi-Fi and Ethernet can be used for uplink connection while BLE is for configuration.
Security
As a Z-Wave Plus certified product, Dkc1001 supports Z-Wave S2 security. The following security modes are directly supported:
Features
Enblink describes Dkc1001 as having the following features:
- Firmware updatable via a compatible Z-Wave gateway
- Communications Connections
- Sensors
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
Tap ""ADD"" button in controller functions menu
Tap ""REMOVE"" button in controller functions menu
Tap ""LEARN"" button in controller functions menu
Factory reset Dkc1001
Tap ""RESET"" button in controller functions menu
If this controller is the primary controller for your network, resetting it will result in the nodes in your network being orphaned and it will be necessary after the reset to exclude and re-include all of the nodes in the network. If this controller is being used as a secondary controller in the network, use this procedure to reset this controller only in the event that the network primary controller is missing or otherwise inoperable.
Please note that this is a user manual Dkc1001 from Enblink is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Dkc1001 and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.